The cover is wrinkly and doesn’t sit flat on the water
When the cover is rolled up and put into a box after manufacture there can be some folding lines or creases in the material. These will eventually disappear as the material has a memory and will always try to lay flat. If you have a roller, you can accelerate the process by leaving the cover rolled up on the roller with the over-cover in place for a few days.
Minor manufacturing distortions in the base material can give it a slightly wrinkly look. This is not a fault, but an unavoidable consequence of the plastic extrusion process.
When Daisy cuts and welds the material to form the finished pool cover, some heat distortion can accentuate this ‘wrinkliness’. The manufacture and welding processes makes this unavoidable and therefore, normal. It does not affect the pool cover’s performance or life span in any way.
Lovely bloke, really genuine
After requesting a slightly bigger pool cover, the customer’s newly installed cover blew off due to the pool being quite full.
So Chris went back out and trimmed the edges a bit for them. Craig, the customer, then called us up to say that Chris did a very good job, and he is a “lovely bloke, really genuine.”
Great work Chris!
Craig
Warnbro WA
Committed to Quality
Daisy Pool Covers only offer energy and water efficient products so our
customers can enjoy their pools for longer.
